Toyota Vehicle Prado

Gather necessary tools and materials

Battery Replacement for Vehicles without Smart Entry & Start System (Type A)

Remove the cover using a coin protected with tape

Remove the depleted battery using the tip of a ball-point pen or similar object

Insert a new battery with the “+” terminal facing up

Battery Replacement for Vehicles without Smart Entry & Start System (Type B)

Cover the tip of the screwdriver with a rag to prevent damage to the key

Turn the engine switch to the 'LOCK' position (for vehicles without a smart entry & start system) or turn the engine switch off (for vehicles with a smart entry & start system)

For right-hand drive vehicles, locate fuse box No.2 on the opposite side of the engine compartment

Fuse Inspection and Replacement

Remove the fuse with the pull-out tool (only type A fuse can be removed using the pull-out tool)

Ensure the vehicle has been parked for at least 3 hours and has not been driven for more than 1.5 km or 1 mile.

Ensure passengers and luggage weight are balanced in the vehicle.

Measure the tire pressure of the front left tire.

Measure the tire pressure of the front right tire.

Measure the tire pressure of the rear left tire.

Measure the tire pressure of the rear right tire.

Is the tire pressure within the recommended range for all tires?

Check battery terminals for corrosion and loose connections

Are there any cracks or loose clamps on the battery?

Is the fluid level between the 'UPPER LEVEL' and 'LOWER LEVEL' lines?

Is the fluid level at or below the 'LOWER LEVEL' line?

Add distilled water if necessary

Turn the engine switch to the correct position

Open the glove box and slide off the damper

Push in each side of the glove box to disconnect the claws

Replace the old filter with a new one

Ensure the 'UP' marks on the filter are pointing up