Toyota Forklift 2FBCA10

VRA (51 and 52), CN₇(1) 51 — CN₇(2) 52, Ω × 1k

VRA (52 and 53), CN₇(2) 52 — CN₇(6) 53, Ω × 1k

VRA (51 and 53), CN₇(1) 51 — CN₇(6) 53, Ω × 1k

Sign off on the accelerator box inspection

1. Align the brake shoe diameter with the inner diameter of the brake drum.

- 2FBCA10, 13, 15 series ..................... 253 mm (10.120")

- 2FBCA20, 25, FBCA30 series ............. 319 mm (12.760")

2. Testing operation of adjusting screw:

(1) Press the fitting cable (2FBCA10, 13, 15 series) to the rear with your finger and perform release action.

(2) Operate the parking brake lever (2FBCA20, 25, FBCA30 series).

(a) When this procedure is followed, the adjusting lever should engage with the next tooth of the adjusting screw.

(b) When it is returned, the adjusting lever should return to the original position—one screw tooth back.

Warning: This procedure requires trained personnel with PPE!

Measure the electrolyte specific gravity

Is the specific gravity within the acceptable range (1.150 - 1.280 at 20°C)?

Instructions for using the hydrometer

Upload a photo of the hydrometer reading

Is the electrolyte clear and free of impurities?

If the electrolyte is defective, follow the Trouble Shooting procedures

Is the electrolyte level sufficient?

If the electrolyte level is low, add refined water up to the prescribed level

Note: Wash the parts with new brake fluid and inspect them on the following items. Repair or replace any part found defective.

(1) Cylinder cup damaged or worn.

2. Inspect the outlet check valve (2FBCA20, 25, FBCA30):

(2) Valve seat worn or foreign matter lodged.

3. Inspect the piston and piston cup:

(1) Piston damaged, rusted or worn eccentric.

(2) Piston cup damaged or worn.

Inspect the preceding article items and the following items, and replace if faulty:

(2) Damages or cracked in anchor bolt