Toyota Forklift 2FBCA13

VRA (51 and 52), CN₇(1) 51 — CN₇(2) 52, Ω × 1k

VRA (52 and 53), CN₇(2) 52 — CN₇(6) 53, Ω × 1k

VRA (51 and 53), CN₇(1) 51 — CN₇(6) 53, Ω × 1k

Sign off on the accelerator box inspection

Align the brake shoe diameter with the inner diameter of the brake drum

Testing operation of adjusting screw

Press the fitting cable (2FBCA10, 13, 15 series) to the rear with your finger and perform release action

Operate the parking brake lever (2FBCA20, 25, FBCA30 series)

Adjusting lever should engage with the next tooth of the adjusting screw

Adjusting lever should return to the original position—one screw tooth back

If operation is defective, perform the following checks

Right-angle contact of adjusting lever with adjusting screw

Warning: This procedure requires technical skill and should be performed by trained personnel only.

Measure the electrolyte specific gravity

Hydrometer properly floated within the outer tube?

Bubbles in the drawn out fluid died out?

Read the graduation at the part protruding above the electrolyte

Hydrometer and thermometer cleaned and dried after use?

Electrolyte turbid or contains impurity?

If defective, take proper measures in accordance with procedures in Trouble Shooting.

Note: Wash the parts with new brake fluid and inspect them on the following items. Repair or replace any part found defective.

(1) Cylinder cup damaged or worn.

2. Inspect the outlet check valve (2FBCA20, 25, FBCA30):

(2) Valve seat worn or foreign matter lodged.

3. Inspect the piston and piston cup:

(1) Piston damaged, rusted or worn eccentric.

(2) Piston cup damaged or worn.

Inspect the preceding article items and the following items, and replace if faulty:

(2) Damages or cracked in anchor bolt