Linde Pallet Truck T 18

Battery Cable and Terminal Inspection

Check the condition of battery cables and terminals

Check the condition of the connector contacts

Do not create any short-circuit

Refer to the recommendations in the 'daily checks' section

Is the electrolyte level up to the base of the filler plug?

Remove the two semi-circular collars (2)

Refit the reservoir (1) to the pump motor unit, ensuring the O-ring (4) is seated properly

Refit the pump motor unit to the chassis

Disconnect the battery before commencing cleaning

Use steam jets or highly detergent products with care

Protect electrical circuits, motors, and switch panels from direct jets

Remove stubborn dirt using a cold detergent before using compressed air

Run the truck to dry motors if water has entered

Remove the front cover for access to the fuses

Check the fuses for the following circuits

Is the charger disconnected from the mains voltage and battery voltage?

Wait at least 10 minutes after disconnecting the mains connector

Open the charger and dismantle the base plate to access the fuses

Check the 25 A fuses for the in-built charger secondary circuit

Press the fuses home in their holder

Drive the pallet truck and check braking by tilting the tiller to the upper area

Drive the pallet truck and check braking by tilting the tiller to the lower area

Did the gas cylinder return the tiller to position (1) automatically?