Continental Tumble Dryer NG120L

Disconnect electrical power from tumble dryer

Close gas shut-off valve to tumble dryer

Verify that the supply inlet pressure is equipped with a pressure regulator

Remove the burner orifice(s) from the spud holder

Affix the appropriate country/gas category label over the main serial plate designations if required.

Pressure Verification and Adjustment

Enter the current gas supply pressure.

Is the gas supply pressure within the acceptable range?

Adjust the gas supply pressure if necessary.

Refer to Figure 12 for guidance during the procedure.

Technician's signature to confirm completion of the procedure.

Ensure the dryer is used for drying water washed fabrics only.

Verify that none of the following items are in the dryer

Ensure surrounding areas are free of flammable and combustible products.

Remove debris from the lint screen filter.

Clean inside of the lint filter compartment.

Clean the area around the exhaust opening and adjacent surrounding area from lint, dust, and dirt.

Disconnect electric power to the tumble dryer before servicing.

Close gas shut-off valve to gas tumble dryer before servicing.

Close steam valve to steam tumble dryer before servicing.

Ensure all guards/panels are in place before starting the tumble dryer.

Reconnect any removed ground wires to ensure proper grounding of the tumble dryer.

Remove all lint from lint compartments and lint screen.

Check hoses for visible signs of deterioration

Is there any visible sign of deterioration on the hoses?

Replace any hose showing signs of deterioration

Ensure all replaced hoses are properly installed