CDR Pompe Pump UCL 40-25-160 60 Hz

Check alignment before commissioning or after maintenance

Ensure motor is stopped and in safety before checking alignment

Leave pump in position and only move the motor

For motors fixed directly to the base, loosen the bolts of the motor feet

For motors fixed on an adjustable plate, loosen the bolts securing the motor plate to the threaded columns

Describe height adjustments made using thin metal sheets or threaded screws

Describe horizontal adjustments made with lateral movements

Verify lubricant type and application limits

Check lubricant quantity for each bracket

Is the oil level at the center of the warning light?

Confirm suitable lubricant brand used

Verify the following conditions before proceeding

Record the current bearing temperature

Is the bearing temperature within the specified range?

Monitor the bearing temperature during the oil change

Check for excessive temperature increase

Measures to take for periods of long inactivity

Periodically start the pump for about five minutes (about once a month) to prevent sediment formation.

Did you run the pump for at least 5-10 minutes this month?

Running the pump after a long period of stop

Review the entire section 'Starting and stopping' and the section 'Maintenance' before restarting the pump.

Follow these suggestions based on the period of inactivity

Fill the pump with inert gas when draining if electrically charged liquids were used.

Wait at least one hour before removing the pump from the plant to allow electrostatic charges to dissipate.

Ensure the following conditions are met before proceeding

Record the current bearing temperature

Is the bearing temperature within the safe range for explosive environments?

Change the oil using the specified lubricant

Describe any unusual observations during the oil change