CDR Pompe Pump UCL 25-25-160 60 Hz

Verify the following conditions before proceeding

Record the current bearing temperature

Is the bearing temperature within safe limits for explosive environments?

Change the oil using the specified lubricant

Describe any unusual observations during the oil change

Ensure proper storage conditions for the pump

Ensure protection caps and lids of the flanges remain on the pump until installation

Is the pump stored for a long period or in severe weather conditions?

If stored for a long period or in severe conditions, ensure additional protective measures

Measures to take for periods of long inactivity

Periodically start the pump for about five minutes (about once a month) to prevent sediment formation.

Did you run the pump for at least once a month or once every three months for approximately 5-10 mins?

Running the pump after a long period of stop

Review the entire section 'Starting and stopping' and the section 'Maintenance' before restarting the pump.

Follow these suggestions based on the period of inactivity

Fill the pump with inert gas when draining if electrically charged liquids were used.

Wait at least one hour before removing the pump from the plant to allow electrostatic charges to dissipate.

Check the oil level using the 'spy' cap

Ensure the oil level corresponds to the center of the warning light

Select the lubricant brand used

Measure and add 300 gr of lubricant for the 1st bracket

Measure and add 900 gr of lubricant for the 2nd bracket

Ensure all safety precautions are followed

Choose the method for volute casing removal

If removing the entire pump, perform the following

If leaving the volute casing connected, perform the following

Perform the following steps for impeller disassembly