CDR Pompe Pump UCL 65-40-160 60 Hz

Verify lubricant specifications

Record the bearing bracket temperature

Is the bearing temperature within safe limits?

Describe any observed temperature changes during the oil change

Verify lubricant type and quantity

Check standard supply of lubricated rolling bearings

Check oil level using the 'spy' cap to ensure it corresponds to the center of the warning light

Confirm suitable lubricant brand used

Check alignment before commissioning or after maintenance

Ensure motor is stopped and in safety before checking alignment

Leave pump in position and move motor for alignment

Loosen bolts of motor feet for motors fixed directly to the base

Loosen bolts securing motor plate to threaded columns for motors on adjustable plate

Adjust motor height by inserting or removing thin metal sheets or adjusting threaded screws

Make horizontal adjustments with lateral movements

Measures to take for periods of long inactivity

Periodically start the pump for about five minutes (about once a month)

Did you run the pump for at least 5-10 minutes?

Running the pump after a long period of stop

Review the section 'Starting and stopping' and the section 'Maintenance'

Fill the pump with inert gas if electrically charged liquids were used

Wait at least one hour before removing the pump from the plant

Recommendations for up to one year of inactivity

Recommendations for beyond one year of inactivity

Ensure all work is performed by authorized personnel only

Choose method for volute casing removal

Steps for leaving volute casing connected