Continental Tumble Dryer NG120N

Disconnect electric power to the tumble dryer before servicing.

Close gas shut-off valve to gas tumble dryer before servicing.

Close steam valve to steam tumble dryer before servicing.

Ensure all guards/panels are in place before starting the tumble dryer.

Reconnect all ground wires removed during servicing to ensure proper grounding.

Remove all lint from lint compartments and lint screen before adjusting the inlet shutters.

Ensure the dryer is used for drying water washed fabrics only.

Confirm that none of the following items are in the dryer

Ensure surrounding areas are free of flammable and combustible products.

Remove debris from the lint screen filter.

Clean inside of the lint filter compartment.

Keep the area around the exhaust opening free from lint, dust, and dirt.

Inform the fire department about the upcoming test if the auxiliary output is connected to notify them.

Disconnect the auxiliary output if it is connected to activate a building sprinkler.

Verify that the auxiliary output contact activates when the system is triggered.

Check the relay rating and ensure it does not exceed 5 Amp, 250VAC.

Reconnect the auxiliary output if it was disconnected prior to the test.

Inform the fire department that the test is complete if they were notified before the test.

Affix appropriate country/gas category label if required

Verify gas supply pressure for the following categories

Enter the current gas supply pressure

Is the gas supply pressure within the acceptable range?

Adjust the gas supply pressure as necessary

Refer to Figure 12 for adjustment guidelines

Ensure no open flames are present in the inspection area

Use non-corrosive leak detection fluid

Check all pipe connections for gas leaks

Was the inspection completed without any incidents?