BINDER Heating Oven ED 720

Verify the functionality of the safety controller

Is the safety controller functioning as expected?

Temperature Set-Point Verification

Enter the current temperature set-point of the safety controller

Enter the desired temperature set-point

Set the safety controller set-point 2 °C to 5 °C above the desired temperature set-point

Is the safety controller set-point correctly adjusted above the desired temperature set-point?

Disconnect the chamber from the power supply

Use adequate personal safety controls

Select the decontamination method

Are all inflammable goods removed from the interior?

Ensure the unit is absolutely dry and ventilated before start-up

Disconnect the chamber from the power supply before cleaning.

Wear protective gloves and goggles.

Avoid skin contact with cleaning agents.

Wipe the surfaces with a moistened towel.

Use appropriate cleaning agents for each part

Completely remove cleaning agents from the surfaces with a moistened towel.

Unpacking and Initial Inspection

Check the chamber and optional accessories for completeness and transportation damage

Inform the carrier if transportation damage has occurred

Remove transportation protection devices and adhesives from the chamber and doors

Take out the operating manuals and accessory equipment

Ensure chamber is lifted from the pallet at its four lower corners with the aid of 2 people

Disconnect the power plug before starting maintenance

Ensure the unit does not become wet during maintenance

Do not remove the rear panel of the unit

Ensure maintenance is conducted by licensed electricians or authorized experts

Inspect and replace the door gasket if necessary

Consult BINDER Service for a maintenance agreement