BINDER Heating Oven ED 400

Unpacking and Initial Inspection

Check completeness of delivery against the delivery receipt

Is there any transportation damage?

Describe any transportation damage observed

Remove transportation protection devices and adhesives from the chamber and doors

Take out the operating manuals and accessory equipment

Ensure chamber is lifted from the pallet at its four lower corners with the aid of 2 people

Disconnect the chamber from the power supply before cleaning.

Wear protective gloves and goggles.

Ensure no food or beverages are nearby.

Wipe the surfaces with a moistened towel.

Use appropriate cleaning agents for each part

Completely remove cleaning agents from the surfaces with a moistened towel.

Observe guideline BGI/GUV-I 850-0 on safe working in laboratories.

Turn the control knob (7) counter-clockwise until the chamber turns off.

Did the indicator lamp (7a) light up and the buzzer sound?

Press the reset button (7b) to release the safety device.

Turn on the chamber as described.

Turn the control knob (7) to its end-stop (position 10) for chamber protection.

Verify the functionality of the safety controller

Is the safety controller functioning as expected?

Temperature Set-Point Verification

Enter the current temperature set-point on the safety controller

Enter the desired temperature set-point

Set the safety controller set-point 2°C to 5°C above the desired temperature set-point

Is the safety controller set-point correctly adjusted above the desired temperature set-point?

Ensure the unit is disconnected from the power source

Verify that the power plug is disconnected

Confirm that maintenance work is conducted by licensed electricians or authorized experts

Ensure the unit does not become wet during maintenance

Do not remove the rear panel of the unit

Replace the door gasket only when cold