BINDER Incubator BD 720

Observe guideline BGI/GUV-I 850-0 on safe working in laboratories.

Turn the control knob (7) counter-clockwise until the chamber turns off.

Did the indicator lamp (7a) light up and the buzzer sound?

Press the reset button (7b) to release the safety device.

Turn on the chamber as described.

Safety Device Class 2 Response Temperature Check

Turn the control knob (7) to its end-stop (position 10) using a coin.

Ensure the unit is disconnected from the power source

Verify that the power plug is disconnected

Confirm that maintenance work is conducted by licensed electricians or authorized experts

Ensure the unit does not become wet during maintenance

Do not remove the rear panel of the unit

Replace the door gasket only when the unit is cold

Disconnect the chamber from the power supply before cleaning.

Wear protective gloves and goggles.

Avoid skin contact with cleaning agents.

Wipe the surfaces with a moistened towel.

Use appropriate cleaning agents for each part

Completely remove cleaning agents from the surfaces with a moistened towel.

Verify the functionality of the safety controller

Is the safety controller functioning properly?

Temperature Set-point Verification

Enter the current temperature set-point of the safety controller

Enter the desired temperature set-point

Set the safety controller set-point 2°C to 5°C above the desired temperature set-point

Is the safety controller set-point correctly adjusted above the desired temperature set-point?

Disconnect the chamber from the power supply

Ensure no water or cleaning agents spill over surfaces

Select the decontamination method

Remove all inflammable goods from the interior