BINDER Heating Oven ED 23-UL

Verify the functionality of the safety controller

Is the safety controller functioning properly?

Temperature Set-point Verification

Enter the current temperature set-point of the safety controller

Enter the desired temperature set-point

Set the safety controller set-point 2°C to 5°C above the desired temperature set-point

Is the safety controller set-point correctly adjusted above the desired temperature set-point?

Unpacking and Initial Inspection

Check the chamber and optional accessories for completeness and transportation damage

Inform the carrier if transportation damage has occurred

Remove any transportation protection devices and adhesives from the chamber and doors

Take out the operating manuals and accessory equipment

Ensure chamber is lifted from the pallet at its four lower corners with the aid of 2 people

Disconnect the chamber from the power supply before cleaning.

Wear protective gloves and goggles.

Ensure no water or cleaning agents are spilled over the inner and outer surfaces.

Select the cleaning agents for the surfaces

Wipe the surfaces with a moistened towel.

Completely remove cleaning agents from the surfaces with a moistened towel.

Observe guideline BGI/GUV-I 850-0 on safe working in laboratories.

Turn the control knob (7) counter-clockwise until the chamber turns off.

Did the indicator lamp (7a) light up and the buzzer sound?

Press the reset button (7b) to release the safety device.

Turn on the chamber as described.

Turn the control knob (7) to its end-stop (position 10) for chamber protection.

DANGER - Electrical hazard. Danger of death.

Ensure the unit does NOT become wet during operation or maintenance work.

Do NOT remove the rear panel of the unit.

Disconnect the unit before conducting maintenance work.

Ensure all maintenance work is conducted by licensed electricians or experts authorized by BINDER.

Was the maintenance work performed by authorized personnel?