BINDER Incubator BD 240

DANGER - Electrical hazard. Danger of death.

Ensure the unit does NOT become wet during operation or maintenance work.

Do NOT remove the rear panel of the unit.

Disconnect the unit before conducting maintenance work.

Ensure all maintenance work is conducted by licensed electricians or experts authorized by BINDER.

Ensure regular maintenance work is performed at least once a year.

Verify that the warranty is valid by ensuring maintenance work is conducted by authorized personnel.

Verify the functionality of the safety controller

Is the safety controller functioning properly?

Temperature Set-point Verification

Enter the current temperature set-point of the safety controller

Enter the desired temperature set-point

Set the safety controller set-point 2°C to 5°C above the desired temperature set-point

Is the safety controller set-point correctly adjusted above the desired temperature set-point?

Unpacking and Initial Inspection

Check the chamber and optional accessories for completeness and transportation damage

Inform the carrier if transportation damage has occurred

Remove any transportation protection devices and adhesives from the chamber and doors

Take out the operating manuals and accessory equipment

Ensure chamber is lifted from the pallet at its four lower corners with the aid of 2 people

Disconnect the chamber from the power supply

Ensure the unit is completely dry before turning it on again

Select the decontamination method used

Were all inflammable goods removed from the interior before hot air sterilization?

Was the unit thoroughly dried and ventilated after spraying with disinfectant?

Disconnect the chamber from the power supply before cleaning.

Wear protective gloves and goggles.

Avoid skin contact with cleaning agents.

Wipe the surfaces with a moistened towel.

Use appropriate cleaning agents for each part

Completely remove cleaning agents from the surfaces with a moistened towel.