BINDER Incubator BD 115-UL

Observe guideline BGI/GUV-I 850-0 on safe working in laboratories.

Turn the control knob (7) counter-clockwise until the chamber turns off.

Did the indicator lamp (7a) light up and the buzzer sound?

Press the reset button (7b) to release the safety device.

Turn on the chamber as described.

Safety Device Class 2 Response Temperature Check

Turn the control knob (7) to its end-stop (position 10) using a coin.

Disconnect the chamber from the power supply

Ensure no water or cleaning agents spill over surfaces

Select the decontamination method

Ensure all inflammable goods are removed from the interior before hot air sterilization

Ensure the unit is absolutely dry and ventilated before start-up

Ensure the unit is disconnected from the power source

Verify that the power plug is disconnected

Confirm that maintenance work is conducted by licensed electricians or authorized experts

Ensure the unit does not become wet during maintenance

Do not remove the rear panel of the unit

Replace the door gasket only when cold

Disconnect the chamber from the power supply before cleaning.

Wear protective gloves and goggles.

Ensure no water or cleaning agents are spilled over the inner and outer surfaces.

Select the cleaning agents used for different surfaces

Use the neutral cleaning agent Art. No. 1002-0016 where recommended.

Wipe the surfaces with a moistened towel.

Verify the functionality of the safety controller

Is the safety controller functioning properly?

Temperature Set-point Verification

Enter the current temperature set-point of the safety controller

Enter the desired temperature set-point

Set the safety controller set-point 2°C to 5°C above the desired temperature set-point

Is the safety controller set-point correctly adjusted above the desired temperature set-point?