BINDER Incubator BD 400

Verify the functionality of the safety controller

Is the safety controller functioning properly?

Temperature Set-Point Verification

Enter the current temperature set-point of the safety controller

Enter the desired temperature set-point

Set the safety controller set-point 2°C to 5°C above the desired temperature set-point

Is the safety controller set-point correctly adjusted above the desired temperature set-point?

Disconnect the chamber from the power supply

Ensure adequate personal safety controls are in place

Select the decontamination method

Use standard commercial surface disinfectants free from acid or halides

Observe guideline BGI/GUV-I 850-0 on safe working in laboratories.

Turn the control knob (7) counter-clockwise until the chamber turns off.

Did the indicator lamp (7a) light up and the buzzer sound?

Press the reset button (7b) to release the safety device.

Turn on the chamber as described.

Turn the control knob (7) to its end-stop (position 10) for chamber protection.

Disconnect the chamber from the power supply before cleaning.

Wear protective gloves and goggles.

Ensure no food or beverages are nearby.

Wipe the surfaces with a moistened towel.

Use appropriate cleaning agents for each part

Completely remove cleaning agents from the surfaces with a moistened towel.

Unpacking and Initial Inspection

Check the chamber and optional accessories for completeness and transportation damage

Inform the carrier if transportation damage has occurred

Remove any transportation protection devices and adhesives from the chamber and doors

Take out the operating manuals and accessory equipment

Ensure chamber is lifted from the pallet at its four lower corners with the aid of 2 people