BINDER Incubator BD 115

Disconnect the chamber from the power supply before cleaning.

Wear protective gloves and goggles.

Avoid skin contact with cleaning agents.

Wipe the surfaces with a moistened towel.

Use appropriate cleaning agents for each part

Completely remove cleaning agents from the surfaces with a moistened towel.

Unpacking and Initial Inspection

Check the chamber and optional accessories for completeness

Is there any transportation damage?

Describe any transportation damage observed

Remove transportation protection devices and adhesives

Take out the operating manuals and accessory equipment

Disconnect the chamber from the power supply

Use adequate personal safety controls

Select the decontamination method

Are all inflammable goods removed from the interior?

Ensure the unit is absolutely dry and ventilated before start-up

Verify the functionality of the safety controller

Is the safety controller functioning properly?

Temperature Set-point Verification

Enter the current temperature set-point of the safety controller

Enter the desired temperature set-point

Set the safety controller set-point 2°C to 5°C above the desired temperature set-point

Is the safety controller set-point correctly adjusted above the desired temperature set-point?

DANGER - Electrical hazard. Danger of death.

Ensure the unit does NOT become wet during operation or maintenance work.

Do NOT remove the rear panel of the unit.

Disconnect the unit before conducting maintenance work.

Ensure all maintenance work is conducted by licensed electricians or experts authorized by BINDER.

Ensure regular maintenance work is performed at least once a year.

Replace the door gasket only when cold.

Consult BINDER Service for a maintenance agreement.