Hyster-Yale Forklift Truck UT35P

Open the radiator cover and loosen the drain cover to let the coolant flow out

Add cooling fluid to radiator up to the top

Stop the engine and allow it to cool down fully

Add cooling fluid to radiator up to the top again

Check the green status visual in the inner indicator

Disconnect the negative earth wire to avoid discharging by additional current release

Ensure the battery is fully charged

Schedule battery charging every 30-45 days if the truck is not used

Check the battery when the green status of the indicator is invisible

Charge or replace the battery if the green status is not visible

Check lubrication of Mast Bearing

Check lubrication of Brake Pedal

Check lubrication of Inching Pedal

Check lubrication of Steering Axle Shaft

Check lubrication of Steering Knuckle Main Bearing

Check lubrication of Steering Rod Bar Pin

Check lubrication of Steering Cylinder Pin

Lubrication System Diagram Reference

Lower the forks to the ground and tilt the mast back

Put transmission in neutral position

Ensure not to touch hot hydraulic oil or parts

Check for leaks in the following areas

Inspect for leaks in the following components

Is there any leaked fuel found following pre-operational checks?

Describe any leaks found and corrective actions taken

Visually inspect the following for problems

Check tire pressure and adjust if necessary

Is the fuel level sufficient for the day's work?