Hyster-Yale Forklift Truck UT20P

Put transmission in neutral position

Ensure no contact with hot hydraulic oil or parts

Check for leaks in the following areas

Inspect for leaks in the following components

Is there any leaked fuel found following pre-operational checks?

Describe any leaks found and corrective actions taken

Visually inspect the following for problems

Check tire pressure and adjust if necessary

Is the fuel level sufficient for the day's work?

Park truck on level ground, lower the forks to the ground and tilt the mast back.

Engage the parking brake, put transmission in neutral position, and turn off engine.

Remove rubber dustproof cap of oil-drain port, insert tube into oil-drain port and waste oil collection bottle, and loosen oil-drain screw.

Press brake pedal repeatedly to allow brake oil to flow from oil-drain port.

Watch the liquid level of brake fluid reservoir and add new oil until the oil from oil-drain port is clean.

Screw down screw of oil-drain port.

Depress brake pedal all the way and hold it there.

Loosen oil-drain port screw and release brake pedal when brake oil flows out.

Perform maintenance on the air cleaner

Replace the filter element as needed

Gently remove the filter element from the canister

Gently tap the filter element to dislodge any contaminants

Clean the inside surface of the canister with a clean soft rag

Inspect the filter element for voids, cuts or tears and replace if required

Install the filter element into the canister

Lower the forks to the ground and tilt the mast back

Put transmission in neutral position

Ensure no contact with hot hydraulic oil and parts