Get instant access to all the maintenance information you need. Empower technicians to perform preventive maintenance with asset packages, ready to use right out of the box.

Documents & Manuals

Find all the essential guides in one place.

Tensioning Guide
Belt-diagram
C-120 pulleys
+ 13 more

Work Order Templates

Pre-built workflows to keep your asset running smoothly.

Daily Electrical System Inspection
Replace Roller and Pulley
Install Engine B-120
+ 29 more

Procedures

Integrate maintenance plans directly into your work orders.

Motion Industries
Applied Industrial Technologies
Electrical Brothers
+ 5 more

Parts

Access the parts list for your equipment in MaintainX.

Drive Motor
B2 Rollers
Tensioning System
+ 40 more

Gardner Denver Base Mounted Compressor L132E

Create an account to install this asset package.

Maintenance Plans for Gardner Denver Base Mounted Compressor Model L132E

Integrate maintenance plans directly into your work orders in MaintainX.

8000 Hourly / 2 Yearly Oil Replacement

Safety Precautions

Shut down the compressor and relieve the system of all pressure

Disconnect, lockout, and tagout the power supply to the compressor package

Ensure no oil is spilled to avoid fire and slip hazards

Remove oil residue and other deposits from the compressor coolers

Check for leaks and address any spilled oil immediately

Oil Change Procedure

Turn off the screw compressor unit and secure it against accidental restarts

Ensure the demister vessel is depressurized

Run this procedure

125 Hourly Compressor Inspection

Safety Precautions

Ensure the compressor is not powered before starting maintenance.

For L90RS-L132RS models, disconnect the system from the mains and wait 10 minutes before touching electrical components.

Press the STOP button on the control panel and wait until the compressor stops and is depressurized.

Ensure the pressure gauge shows no more than 4.4 PSI.

Relieve the compressor unit by slowly opening the screw plug with integrated air vent slots.

Set the on-site main switch to '0' (OFF) and secure it against being switched on.

Inspection and Cleaning

Check for dirt accumulation on the following components

Run this procedure

Interceptor Celaning

Danger!

Preparation

Lock water inflow and water outflow on the compressor.

Provide a suitable container to catch any cooling agents draining from the system.

Interceptor Cleaning Process

Carefully loosen the cover of the dirt interceptor.

Catch any cooling agent draining from the system.

Remove cover and pull filter insert from the housing.

Clean filter insert or replace with a new one.

Run this procedure

4000 Hourly / 1 Yearly Electric Motor Lubrication

Warning: Rotating machinery can cause injury or death. Open main disconnect, lockout and tagout power supply to starter before working on the electric motor.

Stop the unit

Disconnect, lockout and tagout the unit from the power supply

Remove the relief plug and free hole of hardened grease

Wipe lubrication fitting clean and add grease with a hand-operated grease gun

Wipe lubrication fitting clean

Add grease with a hand-operated grease gun

Refer to motor nameplate for appropriate quantity and interval

Leave the relief plug temporarily off. Reconnect the unit and run for about 20 minutes to expel the excess grease

Run this procedure

2000 Hourly / 6 Monthly Air Intake Filter Replacement

Safety Precautions

Ensure the screw compressor is out of operation