Continental Tumble Dryer NJ120E

Check all pipe connections for gas leaks

Use non-corrosive leak detection fluid

Ensure no open flames are used during inspection

Describe any detected leaks and actions taken

Disconnect electric power to the tumble dryer before servicing.

Close gas shut-off valve to gas tumble dryer before servicing.

Close steam valve to steam tumble dryer before servicing.

Ensure all guards/panels are in place before starting the tumble dryer.

Reconnect any removed ground wires to ensure proper grounding of the tumble dryer.

Remove all lint from lint compartments and lint screen.

Ensure all necessary tools and equipment are available

Remove screw plug from pressure tap

Connect a U-tube manometer or similar pressure gauge to the burner orifice (manifold) pressure tap

Start tumble dryer and note pressure once flame is burning

Adjust regulator screw until the burner orifice pressure per applicable table is achieved

Ensure the dryer is used for drying water washed fabrics only.

Confirm no articles containing foam rubber, plastic, or rubber-like materials are in the dryer.

Ensure no articles soiled with cooking oil are in the dryer.

Ensure no articles soiled with flammable liquids or cleaning solvents are in the dryer.

Remove debris from the lint screen filter.

Clean inside of the lint filter compartment.

Ensure the lint filter is cleaned daily.

Inform the fire department about the upcoming test if the auxiliary output is connected to notify them.

Disconnect the auxiliary output if it is connected to activate a building sprinkler.

Verify that the auxiliary output contact activates when the system is triggered.

Check potential uses of the auxiliary output

Reconnect the auxiliary output if it was disconnected prior to the test.

Inform the fire department that the test is complete if they were notified before the test.