Continental Tumble Dryer NH120S

Ensure the dryer is used for drying water washed fabrics only.

Confirm no articles containing foam rubber, plastic, or rubber-like materials are in the dryer.

Ensure no articles soiled with cooking oil are in the dryer.

Ensure no articles soiled with flammable liquids or cleaning solvents are in the dryer.

Remove debris from the lint screen filter.

Clean inside of the lint filter compartment.

Ensure the lint filter is cleaned daily.

Check for visible signs of deterioration on hoses

Is there any visible sign of deterioration on the hoses?

Replacement of Deteriorated Hoses

Replace any hose showing signs of deterioration immediately

Describe any issues found during inspection

Affix the appropriate country/gas category label over the main serial plate designations if required.

Pressure Verification and Adjustment

Measure the current gas supply pressure.

Is the gas supply pressure within the acceptable range?

Adjust the gas supply pressure if necessary.

Refer to Figure 12 for guidance during the procedure.

Technician's signature to confirm completion of the procedure.

Inform the fire department about the upcoming test if the auxiliary output is connected to notify them.

Disconnect the auxiliary output if it is connected to activate a building sprinkler system.

Verify that the auxiliary output contact activates when the system is triggered.

Check potential uses of the auxiliary output

Reconnect the auxiliary output if it was disconnected prior to the test.

Inform the fire department that the test is complete if they were notified before the test.

Ensure no open flames are present in the inspection area

Use non-corrosive leak detection fluid

Check all pipe connections for gas leaks

Was the inspection completed without any incidents?