Vogt Ice Tube-Ice Machine P24 50Hz 1 1/4"

Remove the cutter assembly from the cutter shaft

Remove the drive pins holding the ring gear to the cutter bank

Drive off the ring gear progressively and uniformly to avoid binding

Inspect and clean the cutter bank, removing any burrs, scale, or dirt

Enter the refrigerant operation level

Check frost pattern on freezer shell and oil trap

Refer to the space diagrams to ensure ample room for removing the condenser heads and using the mechanical cleaning equipment.

Order replacement cover gaskets for reassembly.

Disconnect and lock-out power to the ice machine and auxiliary equipment.

Disconnect water piping and drain the condenser.

Loosen the cover (heads) hex nuts and separate the covers from the condenser end to drain additional water.

Remove the heads stud bolts and gasket completely.

Disconnect and lock-out all power

Remove the water tank assembly to access the cutter assembly

Remove the 3/8” cap screws holding the blades to the cutter plate

Install the cap screws and washers but do not tighten

Is the oil level below 1/4 of the sight glass?

Add two quarts of 300 S SU viscosity refrigeration oil if needed

Ensure crankcase heater is energized for a minimum of four hours