

Turn manuals into instant answers
with your AI-powered assistantTurn manuals into instant answers
with your AI-powered assistant
Get instant access to all the maintenance information you need. Empower technicians to perform preventive maintenance with asset packages, ready to use right out of the box.
Find all the essential guides in one place.
Tensioning Guide
Belt-diagram
C-120 pulleys
+ 13 more
Pre-built workflows to keep your asset running smoothly.
Daily Electrical System Inspection
Replace Roller and Pulley
Install Engine B-120
+ 29 more
Integrate maintenance plans directly into your work orders.
Motion Industries
Applied Industrial Technologies
Electrical Brothers
+ 5 more
Access the parts list for your equipment in MaintainX.
Drive Motor
B2 Rollers
Tensioning System
+ 40 more

Kubota Utility Vehicles RTV-X1120D
Create an account to install this asset package.
Integrate maintenance plans directly into your work orders in MaintainX.
100 Hourly / 1 Yearly Air Cleaner Primary Element / Secondary Element Maintenance
Warning: Wear appropriate protective gear when cleaning element.
Remove the air cleaner cover and primary element
Clean the primary element
Note: Pressure of compressed air must be under 205 kPa (2.1 kgf/cm , 30 psi).
Replace the primary element with a new one if carbon or oil adheres to it
Replace the primary element once yearly or after every sixth cleaning, whichever comes first
Check the evacuator valve for dust blockage
Check the rubber seal. Replace if damaged
Important: The air cleaner uses a dry element, never apply oil.
100 Hourly Alternator Belt Tension Adjustment
WARNING: To avoid serious injury: Be sure to stop the engine before checking belt tension.
Vehicle parked on a flat surface
Seat opened
Utility box and maintenance cover removed
Engine stopped
Moderate thumb pressure applied to belt between pulleys
Tension checked and within acceptable limits
Alternator mounting bolts loosened if tension is incorrect
Lever placed between the alternator and the engine block
100 Hourly Battery Condition Check
DANGER: To avoid the possibility of battery explosion
For the refillable type battery, follow the instructions below.
Fluid level is between the UPPER and LOWER levels
DANGER: To avoid serious injury or death
When the battery is being activated, hydrogen and oxygen gases in the battery are extremely explosive.
WARNING: To avoid serious injury
Batteries, battery posts, terminals and related accessories contain lead and lead compounds, and other chemicals known to the State of California to cause cancer and birth defects or other reproductive harm.
Battery cap is not removed while the engine is running
IMPORTANT: Mishandling the battery shortens the service life and adds to maintenance costs.
100 Hourly Fuel Line / Filter Check
WARNING: To avoid serious injury: Be sure to stop the engine and remove the key when attempting to make the following checks and changes.
Never fail to check the fuel lines periodically. The fuel lines are subject to wear and aging. Fuel may leak out onto the running engine, causing a fire.
The fuel line connections should be checked annually or every 100 service hours, whichever comes first.
Park the vehicle on a flat surface, raise the cargo bed, mount the safety support and shut off the engine.
Check the fuel line. If it is made of rubber and ages regardless of service period.
If the fuel line and clamps are found to be damaged or deteriorated, replace them.
Check fuel filter, if it is clogged by debris or contaminated with water, replace it.
When the fuel line is disconnected for maintenance or repair, close both ends of the fuel line with a piece of clean cloth or paper to prevent dust and dirt from entering. In addition, particular care must be taken not to admit dust and dirt into the fuel pump. Entrance of even a small amount of dust or dirt cause premature wear and malfunction of the fuel pump and injector components.
Sign off on the fuel line / filter check
100 Hourly Muffler Cleaning
WARNING: To avoid serious injury: Before touching any part of an exhaust system, be sure that it has sufficient time to cool! Always wear safety goggles and a (face) mask. The particulate matter contained in the muffler contains chemicals that are harmful to people, animals and marine life. If you are unable to do this work, have it done by your KUBOTA Dealer.
Cleaning spark arrester of muffler: This swirl type spark arrester was examined, tested, and qualified in accordance with the USDA Forest Service Standard 5100-1c, 'Spark Arresters for Internal Combustion Engines'.
Maintenance & cleanout procedure: The swirl type spark arrester should be cleaned and inspected after every 100 hours of use.
Vehicle set in an open area away from combustible materials and on flat surface
Parking brake applied and range gear shift lever shifted into the 'NEUTRAL' position
Drain plug located on the bottom of the muffler body removed
Engine started and raised and lowered engine revolution while tapping on the muffler with a rubber mallet until the carbon particles are purged from the muffler
Engine stopped
Drain plug reinstalled
MaintainX CoPilot is your expert colleague, on call 24/7, helping your team find the answers they need to keep equipment running.
Reduce Unplanned Downtime
Ensure your team follows consistent procedures to minimize equipment failures and costly delays.
Maximize Asset Availability
Keep your assets running longer and more reliably, with standardized maintenance workflows from OEM manuals.
Lower Maintenance Costs
Turn any technician into an expert to streamline operations, maintain more assets, and reduce overall costs.
Thousands of companies manage their assets with MaintainX













