Genie Lift Mast AWP-30S

Check the air filter/regulator canister for any water accumulation

Is water visible in the canister?

If water is visible, proceed to the next step. If not, the procedure is complete.

Loosen the drain plug at the bottom of the canister and allow the water to drain out

Sign off on the air filter/regulator canister check

Measure the oil level in the lubricator canister

The oil level must be within 1/2 inch / 12.7 mm from the top of the lubricator canister.

Is the oil level within the specified range?

If not, proceed to the next step.

Upload a photo of the lubricator canister before adding oil.

To add oil, remove the oil lubricator canister from the lubricator base and fill with oil.

Upload a photo of the lubricator canister after adding oil.

Install the canister back onto the lubricator base.

1 Open the battery pack lid to access the battery.

2 Remove the battery vent caps and check the battery acid level. If necessary, add only enough distilled water to cover the plates. Do not overfill prior to the charge cycle.

3 Replace the battery vent caps.

4 Be sure that the DC output cord is properly connected to the battery.

Black to negative, red to positive.

5 Connect the battery charger to a grounded AC circuit.

6 The charger will turn off automatically when the battery is fully charged.

7 Check the battery acid level when the charge cycle is complete. Replenish with distilled water to the bottom of the fill tube. Do not overfill.

Warning: Contact with hot or live circuits could result in death or serious injury. Remove all rings, watches and other jewelry.

Bodily injury hazard. Batteries contain acid. Avoid spilling or contacting battery acid. Neutralize battery acid spills with baking soda and water.

Protective clothing and eye wear worn?

Replenished with distilled water to the bottom of the battery fill tube?

Position the machine on a firm surface directly below the desired work area

Connect to the appropriate power source

Insert the key and turn to platform control

Pull out the red Emergency Stop button to the on position at the ground controls

Twist to release the red Emergency Stop button at the platform controls

Select an outrigger and slide it into a base socket until the outrigger lock pin snaps into place. Adjust the outrigger to level the machine and raise the base casters slightly off the ground. Level the machine using only the outriggers

Check the interlock display lights at the ground controls. Confirm that the corresponding light is on

Repeat this procedure for each of the remaining outriggers