Terex Vehicle SS-842C

- CHANGE TRANSMISSION OIL AND FILTER

- ADJUST EXTENSION -RETRACTION CHAINS

TO CHECK: Proper adjustment can be checked with a tape measure. Extend boom fully, then retract about one inch. On either side of the middle boom section estimate the center.

Place one end of the tape measure on top surface of the boom directly above estimated center.

TOLERANCE: Measurement from top surface of boom to lowest pali of extension chain should be no less than 2 3/8 inches.

TO ADJUST: If the measurement is less than 2318 inches, tighten chain anchor (A), which is located on the top, front of the large boom tube as follows:

Inspect filter element for contamination

Inspect tubing going to filter body from engine for cracks or leaks

Inspect air cleaner body and gaskets for cracks or leaks

Sign off on the air cleaner inspection

Oil level is between the add and full marks

Sign off on the daily engine oil check

Oil visible 1/2 way in sight glass (A)

Sign off on the hydraulic oil level check

DANGER: All tires require a calcium chloride ballast or an optional foam fill to be operated safely. The loss of ballast can affect machine stability and cause a rollover resulting hazard resulting in damage, injury or death.

Valve stem positioned to the top of the tire

Check pressure with tire cold and properly functioning gauge

Sign off on the daily tire check