Genie Work Platform AWP

Observe and Obey: Maintenance inspections shall be completed by a person trained and qualified on the maintenance of this machine.

Scheduled maintenance inspections shall be completed daily, quarterly and annually as specified on the Maintenance Inspection Report.

WARNING: Failure to properly complete each inspection when required may result in death, serious injury or substantial machine damage.

Immediately tag and remove from service a damaged or malfunctioning machine.

Repair any machine damage or malfunction before operating machine.

Keep records on all inspections for three years.

Complete all procedures for daily and quarterly inspections

Inspect and Lubricate the Casters and Wheels

Inspect the Mast Assembly for Wear

1. Inspect the Electrical Wiring Warning! Electrocution hazard. Contact with hot or live circuits may cause death or serious injury. Remove all rings, watches and other jewelry.

1 Inspect the following areas for burnt, chafed, corroded and loose wires:

• inside of the base junction box

• inside of the ground control box

• inside of the mast junction box

• inside of the platform control box

1. Inspect the Operator's and Responsibility Manuals

a. Check to make sure that the operator's and responsibility manuals are present and complete in the storage container at the platform.

b. Examine the pages of each manual to be sure that they are legible and in good condition.

c. Always return the manuals to the storage box alter use.

d. Be sure the storage container and lid are present and in good condition.

NOTICE! Contact your authorized Genie distributor or Genie Industries if replacement manuals are needed.

2. Inspect the Decals and Placards

a.Refer to the Decals section in the Genie IWP Operator's Manual or the Genie AWP Operator's Manual and use the decal list and illustrations to determine that all decals and placards are in place.

b Inspect all decals for legibility and damage. Replace any damaged or illegible decal immediately.

Observe and Obey: Maintenance inspections shall be completed by a person trained and qualified on the maintenance of this machine.

Scheduled maintenance inspections shall be completed daily, quarterly and annually as specified on the Maintenance Inspection Report.

WARNING: Failure to properly complete each inspection when required may result in death, serious injury or substantial machine damage.

Immediately tag and remove from service a damaged or malfunctioning machine.

Repair any machine damage or malfunction before operating machine.

Keep records on all inspections for three years.

Machines that have been out of service for a period longer than 3 months must complete the quarterly inspection.

Inspect the operator's and responsibility manual including storage container

Inspect the Decals and Placards

1. Inspect and Lubricate the Casters and Wheels

Extremely dirty conditions may require that the casters and wheels be inspected and lubricated more often.

Visually inspect each caster and wheel for cuts, cracks, or unusual wear.

Move the machine on a flat smooth surface and check that the casters and wheels roll smoothly.

Pump grease into the caster or wheel until it can be seen coming out of the bearing seal gap.

2. Inspect the Mast Assembly for Wear

Check the side-to-side movement at the top of the column that the platform is mounted to (referred to as the carriage).

Result: The carriage should not be able to touch either side of the adjacent column.