Continental Tumble Dryer NJ120N

Disconnect electric power to the tumble dryer before servicing.

Close gas shut-off valve to gas tumble dryer before servicing.

Close steam valve to steam tumble dryer before servicing.

Ensure all guards/panels are in place before starting the tumble dryer.

Reconnect any removed ground wires to ensure proper grounding of the tumble dryer.

Remove all lint from lint compartments and lint screen.

Disconnect electrical power from tumble dryer

Close gas shut-off valve to tumble dryer

Verify that the supply inlet pressure is equipped with a pressure regulator

Attach manometer to the correct location based on gas valve type

Remove the burner orifice(s) from the spud holder

Affix the appropriate country/gas category label over the main serial plate designations if required

Pressure Verification and Adjustment

Enter the current gas supply pressure

Is the gas supply pressure within the acceptable range?

Adjust the gas supply pressure if necessary

Refer to Figure 12 for guidance

Ensure all necessary tools and equipment are available

Remove screw plug from pressure tap

Connect a U-tube manometer or similar pressure gauge to the burner orifice (manifold) pressure tap

Start tumble dryer and note pressure once flame is burning

Adjust regulator screw until the burner orifice pressure per applicable table is achieved

Inform the fire department about the upcoming maintenance test

Is the auxiliary output connected to a building sprinkler system?

Disconnect auxiliary output if connected to a building sprinkler system

Activate the fire suppression system and check if the auxiliary output is triggered

Verify auxiliary output functions

Reconnect auxiliary output if it was disconnected