Continental Tumble Dryer NJ120L

Disconnect electrical power from tumble dryer

Close gas shut-off valve to tumble dryer

Verify that the supply inlet pressure is equipped with a pressure regulator

Attach manometer to the correct location based on gas valve type

Ensure the following tools are available

Remove screw plug from pressure tap

Connect a U-tube manometer to the burner orifice pressure tap

Note pressure once flame is burning

Disconnect electric power to the tumble dryer before servicing.

Close gas shut-off valve to gas tumble dryer before servicing.

Close steam valve to steam tumble dryer before servicing.

Ensure all guards/panels are in place before starting the tumble dryer.

Reconnect all ground wires removed during servicing to ensure proper grounding.

Remove all lint from lint compartments and lint screen.

Check hoses for visible signs of deterioration

Are there any hoses that need replacement?

Replace any hose showing signs of deterioration

Ensure all replaced hoses are properly installed

Inform the fire department about the upcoming test if the auxiliary output is connected to notify them.

Disconnect the auxiliary output if it is connected to activate a building sprinkler.

Verify the auxiliary output contact activates during the fire suppression system test.

Check the relay rating and ensure it does not exceed 5 Amp, 250VAC.

Reconnect the auxiliary output if it was disconnected prior to the test.

Inform the fire department that the test is complete if they were notified before the test.