Get instant access to all the maintenance information you need. Empower technicians to perform preventive maintenance with asset packages, ready to use right out of the box.

Documents & Manuals

Find all the essential guides in one place.

Tensioning Guide
Belt-diagram
C-120 pulleys
+ 13 more

Work Order Templates

Pre-built workflows to keep your asset running smoothly.

Daily Electrical System Inspection
Replace Roller and Pulley
Install Engine B-120
+ 29 more

Procedures

Integrate maintenance plans directly into your work orders.

Motion Industries
Applied Industrial Technologies
Electrical Brothers
+ 5 more

Parts

Access the parts list for your equipment in MaintainX.

Drive Motor
B2 Rollers
Tensioning System
+ 40 more

Fisher Snowplow 8'6" HD2

Create an account to install this asset package.

Maintenance Plans for Fisher Snowplow Model 8'6" HD2

Integrate maintenance plans directly into your work orders in MaintainX.

Fuse Replacement

Preparation

Ensure the vehicle ignition switch is OFF

Disconnect the electrical connections to the snowplow

Inspection

Identify the fuse type and location

Is the fuse blown?

Replacement

Remove the blown fuse

Select the correct replacement fuse

Run this procedure

Hose / Fitting Replacement

WARNING: Lower the blade when the vehicle is parked. Keep 8' clear of the blade. Temperature changes could change hydraulic pressure, causing the blade to drop unexpectedly or damaging hydraulic components. Failure to do this could result in serious personal injury.

DO NOT use thread sealant/tape on hoses or fittings. This could damage the product. Follow recommended replacement procedures for fittings and hoses.

Preparation

Lower the snowplow completely and turn the control OFF.

Loosen fill plug slowly to relieve any pressure in the reservoir.

Hose and Fitting Removal

Carefully note hose routings and the positions of any protective hose wraps for proper reassembly.

Loosen hoses or fittings slowly to relieve any residual pressure.

Loosen and unscrew the hose flare nut from the fitting to remove a hose.

Run this procedure

Scrape Lock Adjustment

Preparation

Park the vehicle on a smooth, level, hard surface, such as concrete.

Lower the blade to the ground and turn the control OFF.

Leave the snowplow attached to the vehicle.

Turn the vehicle ignition to the 'OFF' position.

Initial Disconnection and Setup

Disconnect the snowplow battery cable from the vehicle battery cable.

Remove the hydraulic unit cover.

Loosen the breather/fill plug slowly to relieve any pressure in the reservoir.

Run this procedure

Preseason Snowplow Check

WARNING: Lower the blade when the vehicle is parked. Keep 8' clear of the blade. Temperature changes could change hydraulic pressure, causing the blade to drop unexpectedly, or damaging hydraulic components. Failure to do this could result in serious personal injury.

Electrical System Check

Clean all electrical connections.

Tighten all electrical connections.

Coat electrical connections with dielectric grease to prevent corrosion.

Hydraulic System Check

Check hydraulic system for leaks.

Inspect for cracked or damaged hoses.

Drain hydraulic system and refill with recommended hydraulic fluid.

Run this procedure

Snowplow Headlamp Check

Electrical Connection Check

Are all electrical plugs connected?