Stoelting Foodservice Equipment Ice Cream Machine F131-38I2-YG2

Install the rear seal o-ring onto the auger.

Lubricate the outside of the o-ring with a generous amount of Total Blend lubricant.

Lubricate the inside metal surface of the rear seal and install it onto the auger shaft.

Ensure the outside of the rear auger seal is not lubricated.

Lubricate the hex drive end of the auger with a small amount of Total Blend lubricant.

Is Total Blend sanitary lubricant or equivalent used for lubrication?

Is the lubricant certified for use on food processing equipment?

Remove the front auger support and bushing

Remove the auger assembly from the machine

Pull the auger out of the freezing cylinder slowly

Carefully remove each of the plastic flights with springs as the auger is being pulled out

Keep the rear of the auger tipped up once it is clear of the freezing cylinder to prevent the rear seal assembly from dropping

Wipe the lubricant off of the hex end of the auger with a paper towel

To assemble the machine parts, refer to the following steps.

Repeat for each freezing cylinder.

Use Total Blend sanitary lubricant or equivalent when lubrication of machine parts is specified.

Ensure not to use more than one packet of Total Blend per freezing cylinder.

Verify that lubricants used are certified for food processing equipment.

Install the o-rings onto the spigot bodies and apply a thin layer of sanitary lubricant to the o-rings.

Install the spigot bodies through the bottom of the front door.

Ensure the machine is disconnected from electrical supply before servicing.

Verify that the service is performed by a qualified electrician/refrigeration specialist.

Tighten drive belts if necessary.

WARNING: Hazardous voltage. The machine must be disconnected from electrical supply before servicing.

Ensure the machine is disconnected from electrical supply

WARNING: Service must be completed by a qualified electrician/refrigeration specialist.

Check the condenser filter for dirt

Is cleaning of the condenser filter necessary?

Clean the condenser filter if necessary