Still Truck R 07-25

DANGER! Risk of very serious injury due to steering failure!

WARNING! These fluids are pressurised during operation of the truck and are hazardous to your health!

ENVIRONMENT NOTE: Hydraulic fluid is a water-polluting substance!

Open filler cap of the steering fluid tank

Remove and dispose of steering fluid filter

Place a suitable drip tray under the steering fluid tank

Warning: Ensure the engine is off and cool before starting the procedure

Breather filter pulled out and disposed

Sign off on the filter replacement

DANGER! Increased risk of accident as a result of a failure of the brake system! Never operate the truck when the brake fluid level is low. Immediately fill the brake fluid reservoir and check the brake system for leaks.

NOTE: A brake fluid indicator is fitted and will indicate when the brake fluid level is too low. However it is advisable to check the brake fluid level every 1000 operating hours.

Remove the cover of the brake fluid reservoir between the seats

Unscrew the filler cap and make sure that the level reaches the maximum mark (1). The level must never drop below the minimum mark (2)

Fill up brake fluid as required and in accordance with the lubrication table

Sign off on the brake fluid level check

NOTE: Dependent on the battery charger used, the equalising charge may not begin until 24 hours have elapsed. A period when no shifts are running, such as the weekend, is therefore ideal for performing the equalising charge

NOTE: Observe the information in the operating instructions of the battery charger regarding how to perform an equalising charge

- Starting the equalising charge!

2. After charging, leave the battery in the battery charger

NOTE: The battery charger remains switched on. Depending on the battery charger used, the equalising charge starts after between 6 and 24 hours. The equalising charge takes up to 2 hours

NOTE: Please refer to the operating instructions from the manufacturer of the battery charger

- Ending the equalising charge!

NOTE: The equalising charge ends automatically. If the battery is required during this process, you can interrupt the equalising charge by pressing the "stop button" on the battery charger

• Hinges and locking mechanisms

• Door hinges and locking mechanisms

• Sliding doors, door runners and the corresponding mechanisms as required;