Pack Mule Electric Vehicle PCT-3200 NXG

Place battery into service and complete a full discharge and charge cycle.

Add approved water if needed after the first cycle is completed.

Ensure battery is not discharged beyond 80%.

Check if the specific gravity is above 1.150.

Storage and Shipment Precautions

Check electrolyte levels are above the separator and 1/8” (3.175mm) below the vent well.

Remove power by disconnecting the battery

Discharge the capacitors in the controller

Remove any dirt or corrosion from the connector areas

Ensure the controller is not subjected to pressured water flow

Ensure the area is well-ventilated

Wear protective gloves and eyewear

Measure sodium bicarbonate (baking soda)

Mix sodium bicarbonate with water

Apply cleaning solution to battery tops and sides

Check tire pressure for pneumatic tires

Is the tire pressure at 60 psi for LRB tires?

Is the tire pressure at 90 psi for LRC tires?

Position the jack in the proper position (Figure 12)

Loosen the lug nuts on the wheel to be changed

Raise the jack until the tire is clear of the surface