Pack Mule Electric Vehicle PC-325 NXG

Ensure the battery is disconnected before cleaning

Gather necessary cleaning materials

Mix sodium bicarbonate with water

Apply the cleaning solution to the top and sides of the batteries

Allow the solution to sit for three minutes

Rinse the area thoroughly with low-pressure, clear water

Enter the tire pressure for LRB tires

Is the tire pressure for LRB tires maintained at 60 psi?

Enter the tire pressure for LRC tires

Is the tire pressure for LRC tires maintained at 90 psi?

Position the jack in the proper position (Figure 12)

Loosen the lug nuts on the wheel to be changed

Place battery into service and complete a full discharge and charge cycle.

Is the electrolyte level adequate after the first cycle?

Add approved water if needed after the first cycle.

Ensure battery is not discharged beyond 80%.

Check the specific gravity of the battery.

Is the specific gravity above 1.150?

Remove power by disconnecting the battery

Discharge the capacitors in the controller

Remove any dirt or corrosion from the connector areas

Ensure the controller is not subjected to pressured water flow