KSB SE & Co. KGaA Standardised Chemical Pump MCPK065-40-200

Caution: Mixing Greases Of Differing Soap Bases

Bearing Cleaning and Adjustment

Adjust the re-lubrication intervals to the grease used

Half-fill the bearing cavities with grease

Fill the cavities in the bearing cover until they are about 1/3 full

Undo hexagon nuts 920.02 at gland follower 452 and remove the gland follower

Unscrew hexagon nuts 920.04, if any

Remove casing cover 161 from bearing bracket 330

Remove stuffing box ring 454.01 and drip plate 463.01

Remove packing rings 461.01 and lantern ring 458.01, if any, from the packing chamber

Pull shaft protecting sleeve 524.01 and thrower 507.01 off shaft 210

WARNING — Back Pull-Out Unit Tipping Over. Risk of crushing hands and feet!

Suspend or support the bearing bracket at the pump end.

Suspend or support bearing bracket 330 to prevent it from tipping over, if required.

Unbolt support foot 183 from the baseplate.

Undo hexagon nut 920.01 at the volute casing.

Pull the back pull-out unit out of the volute casing.

Remove and dispose of joint ring 411.10.

Place the back pull-out unit on a clean and level surface.

Check that all tools are accounted for and stored properly.

DANGER — Excessive Temperatures

Check the condition of the lubricant regularly

Verify oil change intervals based on temperature

Ensure oil quality meets specifications

Select the correct oil quantity for the model

NOTE: On pump sets with spacer-type couplings, the back pull-out unit can be removed while the motor remains bolted to the baseplate.

WARNING — Motor Tipping Over. Risk of crushing hands and feet!

Suspend or support the motor to prevent it from tipping over.

Disconnect the motor from the power supply.

Unbolt the motor from the baseplate.

Shift the motor to separate it from the pump.