KSB SE & Co. KGaA Standardised Chemical Pump MCPK080-50-315

Verify that the system is depressurized

Record the differential pressure across the filter

Is the differential pressure within the acceptable range?

⚠ WARNING — Fluids And Supplies Posing A Health Hazard And/Or Hot Fluids And Supplies. Hazard to persons and the environment!

Wear safety clothing and a protective mask, if required.

Have all legal regulations on the disposal of fluids posing a health hazard been observed?

Collect and properly dispose of flushing medium and any residues of the fluid handled.

Use connection 6B to drain the fluid handled

Are there any residues that might lead to corrosion damage when coming into contact with atmospheric humidity?

Wear safety clothing and a protective mask, if required

Ensure a suitable container for the used oil is on hand

Place the container underneath the screw plug

Undo the screw plug at the bearing bracket and drain the oil

Re-insert and re-tighten the screw plug after draining

Collect and dispose of any lubricants

CAUTION — Mixing Greases Of Differing Soap Bases

Adjust the re-lubrication intervals to the grease used

Half-fill the bearing cavities with grease

Fill the cavities in the bearing cover until they are about 1/3 full

Observe and carry out notes and steps from Section 7.4.1 to Section 7.4.7

Push shaft 210 with deep-groove ball bearing 321.01/.02 out of the bearing bracket

Heat up the deep-groove ball bearing to 80°C and pull it off shaft 210

Pull deep-groove ball bearing 321.01/.02 off the shaft in cold condition for grease-lubricated models

Dispose of joint rings 400.01/.02