JCB JCB Backhoe Loader 3CX 14M4CE 3CX 14M4CE

- Change Engine Oil and Filter (AK and AR Build)

- Change Engine Oil and Filter (RE and RG Build)

- Change Engine Air Cleaner Outer Element

- Change Engine Fuel Filter (AK and AR Build)

- Change Engine Fuel Filter (RE and RG Build)

- Clean Lift Pump Strainer (AK and AR Build Only)

- Drain and Clean Engine Fuel Sedimenter

- Check Fan Belt Tension/Condition

Check Axle Oil Level (incl. Hubs when applicable)

Change Axle Oil - Limited Slip Differential

Check Steer Axle Movement/Shimming

Grease Steer Axle Pivots and Linkages

- Change Engine Oil and Filter (AK and AR Build)

- Change Engine Oil and Filter (RE and RG Build)

- Change Engine Fuel Filter (AK and AR Build)

- Change Engine Fuel Filter (RE and RG Build)

- Clean Lift Pump Strainer (AK and AR Build Only)

- Drain and Clean Engine Fuel Sedimenter

- Check Fan Belt Tension/Condition

- Check Engine Mounting Bolts for Tightness

Warning: If a wheel stud is renewed, all the studs for that wheel must be changed as a set, since the remaining studs may have been damaged

On new machines, and whenever a wheel has been removed, check the wheel nut torques every two hours until they stay correct

Every day, before starting work, check that the wheel nuts are tight

The correct torques are shown in the table below: Front - Nm 680 / Ibf ft 500, Rear - Nm 680 / Ibf ft 500

Sign off on the wheel nut check

Check the fire extinguisher for damage, security and signs of leaking

Check that the gauge B indicates that the extinguisher is charged ie. the needle is in the GREEN segment

Note: If the needle is in or very near the RED segment at either end of the gauge, the extinguisher must be serviced or replaced

Make sure the safety pin is fitted and secure

The extinguisher should be serviced every 12 months by a suitably qualified person

Check the ROPS/FOPS Structure (p.49)

Sign off on the fire extinguisher service