JCB JCB Backhoe Loader 215 215

Park the machine on firm level ground, engage the parking brake and set the transmission to neutral. Lower the attachments to the ground and stop the engine

Machine parked and prepared for cleaning?

Clean the machine using water and/or steam. Do not allow mud, debris etc to build upon the machine, pay particular attention to the following areas:

Engine and transmission cleaned?

WARNING! Airborne particles of light combustible material such as straw, grass, wood shavings, etc. must not be allowed to accumulate within the engine compartment or in the propshaft guards (when fitted). Please inspect these areas frequently and clean at the beginning of each work shift or more often if required. Before opening the engine cover, ensure that the top is clear of debris

Engine compartment and propshaft guards cleaned?

Avoid using neat detergent - always dilute detergents as per the manufacturer's recommendations, otherwise damage to the paint finish may occur

WARNING! When a seat belt is fitted to your machine replace it with a new one if it is damaged, if the fabric is worn, or if the machine has been in an accident. Fit a new seat belt every three years

Inspect the seat belt for signs of fraying and stretching

Check that the stitching is not loose or damaged

Check that the buckle assembly is undamaged and works correctly

Check that the belt mounting bolts are undamaged, correctly fitted and tightened

Sign off on the seat belt maintenance

These instructions are for adding air to a tyre which is already inflated. If the tyre has lost all its air pressure, call in a qualified tyre mechanic. The tyre mechanic should use a tyre inflation cage and the correct equipment to do the job

An exploding tyre can kill, inflated tyres can explode if overheated. Do not cut or weld the rims. Use a tyre/wheel specialist for all repair work

Before you add air to the tyre, make sure it is correctly fitted on the machine or installed in a tyre inflation cage

Use only an air supply system which includes a pressure regulator. Set the regulator no higher than 1.38 bar (20 psi) above the recommended tyre pressure. See Section F, Technical Data for recommended tyres and pressures for your machine

- Change Axle Oil (incl. Hubs when applicable)

- Change Axle Oil - Limited Slip Differential

- Check Tyre Pressures/Condition

- Check Steer Axle Movement/Shimming

Drain and Clean Engine Fuel Sedimenter

Sign off on the engine maintenance