Aerzen Blower GM6S

8.2.1 Maintenance schedule for normal operation

After every 16,000 operational hours or every 2 years

Chapter 8.3.5 'Changing oil' on page 150

Follow the full oil draining and filling procedure

Performing checks after commissioning

Check and correct oil level if necessary

Check and correct alignment of the sheaves if necessary

Check and correct oil level if necessary

Check and correct alignment of the sheaves if necessary

8.2.1 Maintenance schedule for normal operation — Weekly

Check for damage and thorough stability

Remove dirt from the belt guard

Is the belt guard fastener tight?

Is there any lubricant bleeding out of the drive motor?

Remove any dirt from the outer belt guard

Is the belt guard sufficiently stable and undamaged?

8.2.1 Maintenance schedule for normal operation

Inspect replacement and expendable parts

Change replacement and expendable parts if necessary

8.2.1 Maintenance schedule for normal operation

After every 4,000 op. hrs or every 6 months

Chapter 8.3.5 'Changing oil' on page 150

Is the discharge temperature over 140 °C?

Follow the full oil draining and filling procedure as described in Initial 500 Hours Lube Oil Change