Xylem Pump E-1531 2.5A

1.2.2 Safety instruction decals / 5.3 Start the pump

Replace pump seal if leaks are found

Monitor the pump while it is operating

Check the pump for the following issues

Is the pump operating within normal levels?

Shut down the pump immediately if it exceeds normal levels

Correct the problem if the pump was shut down

Ensure the pump is not running dry to prevent seal damage

5.6 Note on the packed pump operation

Describe the adequate leakage rate for the pump

Is the temperature rise within the limit?

Is cooling water provided if steam persists?

Back off the packing gland nuts or screws until the gland is loose

Ensure all replacement parts are available before disassembly

Inspect pump parts according to pre-assembly topics

Replace any part that does not meet the required criteria

Clean pump parts in solvent to remove oil, grease, and dirt

Protect machined surfaces while cleaning parts

Replace or repair parts as required

Store in a covered and dry location

Ensure the unit is free from heat, dirt, and vibrations

Rotate the shaft by hand several times

Treat bearing and machined surfaces for preservation

Refer to the drive unit manufacturer for long-term storage procedures

6.1 Bearing maintenance — Bearing lubrication schedule

Verify motor bearings require no initial lubrication

Document motor manufacturer's lubrication interval recommendations

Confirm motor was lubricated at the factory