Toyota Forklift 8FBE20T

Every month, at the end of charging and with the battery disconnected from the battery charger, check the battery voltage and the voltage of every single element, recording it on a special chart. If a significant variation is found with respect to the previous record, carry out a new series of checks on the data found and, if necessary, request the intervention of the service center of the battery supplier.

If the autonomy is not sufficient, proceed as follows:

- Check that the work being done is compatible with the battery capacity

- Check the state of the rectifier

- Check the discharge limiter.;

Check the resistance between Terminal 5 - 6

Check the resistance between Terminal 4 - 6

Check the resistance between Terminal 1 - 2

Check the resistance between Terminal 2 - 3

Fit the potentiometer temporarily

NOTICE! Incline the accelerator potentiometer, turning it 10 degrees clockwise using the fixing holes, then proceed with installation.

Check the output voltage of the accelerator potentiometer with the pedal released

Check the standard accelerator potentiometer values: POT ACC R3

2) Disconnect the battery connector.

3) Remove the cover card bracket.

4) Disconnect the electrical wiring.

The assembly procedure is the reverse of the disassembly procedure.

After replacing the card, the vehicle settings must be repeated (see heading CALIBRATIONS).;

2) Disconnect the battery connector.

4) Disconnect the electrical wiring.

The assembly procedure is the reverse of the disassembly procedure.

After replacing the potentiometer, the vehicle settings must be repeated (see heading CALIBRATIONS).;

Close the battery cover after assembling the side plate