Toyota Skid-Steer Loader 30-5SDK8

- Injection timing - Measure and correct and adjust as required.

- Glow plug heat coil breakage - Inspect and correct and replace as required.

- Intake heater - Inspect and correct and replace as required.

- Specific gravity - Measure and correct and adjust as required.;

Warning: This procedure requires trained personnel with PPE!

Note any issues encountered during the replacement

Sign off on the component replacement

The element can be taken out after removing the three catches fixing the element.

1. Tap the element filter paper lightly without causing any damage or blow dust off with compressed air (700kPa [7kgf/cm2] or less) from inside.

2. After element cleaning, remove any dust in the evacuator valve.

- Always replace the element if the filter paper is torn or damaged.

- Wash the element if heavily contaminated.

1. Soak the element in water containing neutral detergent for approximately 30 minutes and then wash. Use care not to scratch the filter paper.

2. After washing, rinse the element with clean water (water pressure less than 280kPa [2.8kgf/cm2]).

Caution: Clean off the grease fitting nipples before lubricating.

Cleaned grease fitting nipples?

Lubricated the arm and cylinder portion joint pin?

Sign off on the arm system lubrication

Warning: Be sure to use distilled water for battery electrolyte. Also, wear protective glasses when working on the battery.

Note: Perform battery maintenance after removing the radiator duct. The radiator duct can be removed by loosening the two bolts on its upper face.

The battery electrolyte is between the upper and lower levels (10 to 15 mm from the top of the plates).

If the electrolyte level is below the lower level, did you remove the cap and add distilled water to the upper level through the water inlet port?

Sign off on the battery electrolyte check