
Turn manuals into instant answers
with your AI-powered assistantTurn manuals into instant answers
with your AI-powered assistant
Get instant access to all the maintenance information you need. Empower technicians to perform preventive maintenance with asset packages, ready to use right out of the box.
Find all the essential guides in one place.
Tensioning Guide
Belt-diagram
C-120 pulleys
+ 13 more
Pre-built workflows to keep your asset running smoothly.
Daily Electrical System Inspection
Replace Roller and Pulley
Install Engine B-120
+ 29 more
Integrate maintenance plans directly into your work orders.
Motion Industries
Applied Industrial Technologies
Electrical Brothers
+ 5 more
Access the parts list for your equipment in MaintainX.
Drive Motor
B2 Rollers
Tensioning System
+ 40 more

Toyota Vehicle HDJ79
Create an account to install this asset package.
Integrate maintenance plans directly into your work orders in MaintainX.
2 Weekly Tire Pressure Check
Warning: Incorrect tire pressure can reduce tire life and make your vehicle less safe to drive.
Tire pressures at the proper level?
Enter the tire pressure reading
Tire pressure checked when tires are cold?
Tire pressure gauge used for checking?
Tire pressure higher after driving?
Tire inflation valve caps reinstalled?
If any tire frequently needs refilling, describe the issue
Sign off on the tire pressure check
Battery Check
CAUTION: BATTERY PRECAUTIONS
The battery produces flammable and explosive hydrogen gas. Do not cause a spark from the battery with tools. Do not smoke or light a match near the battery.
The electrolyte contains poisonous and corrosive sulfuric acid. Avoid contact with eyes, skin or clothes. Never ingest electrolyte. Wear protective safety glasses when working near the battery. Keep children away from the battery.
EMERGENCY MEASURES: If electrolyte gets in your eyes, flush your eyes with clean water immediately and get immediate medical attention. If possible, continue to apply water with a sponge or cloth while en route to the medical office.
Check the battery for corroded or loose terminal connections, cracks, or loose hold-down clamp.
If the battery is corroded, wash it off with a solution of warm water and baking soda. Coat the outside of the terminals with grease to prevent further corrosion.
If the terminal connections are loose, tighten their clamp nuts-but do not overtighten.
Tighten the hold-down clamp only enough to keep the battery firmly in place. Overtightening may damage the battery case.
NOTICE: Be sure the engine and all accessories are off before performing maintenance.
Battery Fluid Check
Checking battery fluid
CHECKING BY FLUID LEVEL LINES
The fluid (electrolyte) level must be between the upper and lower lines.
When checking the fluid level, look at all six cells, not just one or two.
If the level is lower than the lower line, add distilled water. (See "ADDING DISTILLED WATER".)
ADDING DISTILLED WATER
1. Remove the vent plugs.
2. Add distilled water to cells needing fluid.
If the side of your battery is covered, check the water level by looking down directly above the cell as illustrated above.
Battery Recharge
Warning: Battery produces hydrogen gas during recharging. Ensure sufficient ventilation.
Vent plugs removed
Is the battery installed on the vehicle?
If battery is installed on the vehicle, disconnect the ground cable.
Power switch on the recharger is off when connecting the charger cables to the battery and when disconnecting them.
Battery is being charged in an unconfined area
Never recharge the battery while the engine is running. Also, be sure all accessories are turned off.
Sign off on the battery recharge procedure
Elgine Coolant Level Check
Warning: Do not remove the radiator cap when the engine is hot.
Is the engine cold?
Enter the coolant level in the reservoir
Is the coolant level between the 'FULL' and 'LOW' lines?
If the level is low, add ethylene-glycol type coolant.
Did the coolant level reach the 'FULL' line after adding coolant?
If the coolant level drops within a short time, there may be a leak in the system.
Any visible leaks in the radiator, hoses, radiator cap, drain cock, or water pump?
If no leak is found, have your Toyota dealer test the cap pressure and check for leaks in the cooling system.
MaintainX CoPilot is your expert colleague, on call 24/7, helping your team find the answers they need to keep equipment running.
Reduce Unplanned Downtime
Ensure your team follows consistent procedures to minimize equipment failures and costly delays.
Maximize Asset Availability
Keep your assets running longer and more reliably, with standardized maintenance workflows from OEM manuals.
Lower Maintenance Costs
Turn any technician into an expert to streamline operations, maintain more assets, and reduce overall costs.
Thousands of companies manage their assets with MaintainX













