Bobcat Side Discharge Mower 942296

Warning: Do not wash the cartridge or use compressed air which can cause damage.

Enter the hours on the machine's hour meter

Is the cartridge clean after tapping gently?

Is the cartridge dirty, bent or damaged?

Sign off on the air cleaner paper cartridge check

Check oil level with the dipstick

Replace dipstick before starting engine

Warning: This operation check requires trained personnel with PPE!

Engine starts and runs at 1/2 throttle with the operator on the machine but raised off the seat

Engine stops when parking brake is moved to the OFF position

Engine stops when traction lever is moved out of the neutral lock position

Engine stops when blades are turned on

Note: Each check should kill the engine after 1/2 second. A 1/2 second delay is built into the system to prevent engine cutout when traversing rough terrain.

Does the Operator Presence Interlock System operate correctly in start or run?

Report any issues found during the check

Sign off on the Operator Presence Interlock System - Run Operation Check

Ensure the exterior of the transaxle is free of debris before starting the procedure.

Removed the three 1/4\ filter guard screws and filter guard A?"

Removed the oil filter B from the transaxle and discarded?

Dispose of used oil in accordance with local requirements.

Applied a film of new oil to the gasket of the new replacement filter?

Installed the new filter by hand, turned 3/4 to one full turn after the filter gasket contacts the filter base surface?

Re-installed the filter guard and torqued the three screws to 65 in. lbs. each?

Removed cap C, filled the transaxles through the expansion tank D with approximately 4 quarts of SAE 20W-50 engine oil?

Caution: Do not overfill! If you overfill the transaxle while the unit is \cold\"

Engines equipped with dual element air cleaners have a paper air cleaner element with an oiled, foam precleaner element on the dirty side of the paper element. Both should be inspected regularly and maintained.

Clean and re-oil precleaner element every 25 hours (more often under dusty conditions).

Wash precleaner in kerosene or liquid detergent and water.

Wrap precleaner in cloth and squeeze to remove cleaner.

Saturate precleaner in engine oil. Squeeze to remove excess oil.

Re-install precleaner. Reassemble air cleaner components and screw assembly down tight.

Sign off on the precleaner element cleaning