Flowserve Pump Mark 3 2K 4x3-13

Verify lubrication intervals based on temperature

Ensure bearing temperature is under 71°C (160°F) for this interval

Remove pipe plug from inboard and outboard bearing locations for regreasable single shielded bearings

Verify grease type for relubrication

Clean out bearing housing after relubricating three times

Horizontal Lubrication Relubrication Amounts

Enter Group 1 inboard lubrication amount (cm3)

Enter Group 1 outboard lubrication amount (cm3)

Pre-Commissioning Procedure — Pre Start-Up Checks

Ensure all components are properly secured and installed

Verify settings and installations

Check lubrication and cooling systems

Ensure pump instrumentation is operational

Pump Lubricants — Oil Bath (Mineral Oil)

Verify lubrication intervals based on temperature

Is the bearing temperature between 71-80°C (160-175°F)?

Fill the bearing housing to the center of the oil sight glass with the proper type oil

Ensure no detergent oils are used

Adjust gland packing for visible leakage and alignment

Check for leaks from gaskets and seals

Verify correct functioning of the shaft seal

Enter remaining hours before lubricant change is required

Is the duty condition within the safe operating range for the pump?

Pump Lubricants — Oil Bath (Mineral Oil)

Check lubrication intervals based on temperature

Verify bearing temperature is 80-94°C (175-200°F)

Fill the bearing housing to the center of the oil sight glass with the proper type oil

Ensure no detergent oils are used