Flowserve Pump Mark 3 2K 3x2-13

Pump Lubricants — Grease for Life

Verify that double shielded or double sealed bearings are packed with grease by the manufacturer

Confirm that bearings are not relubricated

Assess the operating temperature and speed of the bearings

Determine if the replacement interval is affected by operating conditions

Check if shielded bearings are operating cooler than expected

Measure the current process temperature

Enter the measured impeller clearance

Verify impeller clearance settings by temperature

Is the impeller clearance within the specified range for the current temperature?

Adjust the impeller clearance if necessary

Record any adjustments made to the impeller clearance

Pump Lubricants — Oil Bath (Synthetic Oil)

Adjust gland packing for visible leakage and alignment

Check for leaks from gaskets and seals

Is the shaft seal functioning correctly?

Enter remaining hours before lubricant change is required

Is the duty condition within the safe operating range for the pump?

Pump Lubricants — Oil Bath (Mineral Oil)

Check lubrication intervals based on temperature

Verify bearing temperature is under 71°C (160°F)

Fill the bearing housing to the center of the oil sight glass with the proper type oil

Ensure oil is free of water, sediment, resin, soaps, acid, and fillers

Check oil contains rust and oxidation inhibitors

Select the amount of oil required based on pump type

Confirm no detergent oils are used