Daikin Air Conditioner Outdoor Unit RKC35PVM

Wait for 10 minutes after turning off all power supplies before starting disassembly

Ensure pipes and parts heated by gas brazing machine are cool to avoid burns

Ventilate the room if refrigerant gas leaks during work

Avoid exposing refrigerant gas to flames to prevent toxic gas generation

Do not discharge refrigerant gas into the atmosphere

Warning: Wait for 10 minutes after turning off all power supplies before disassembling

Pull out the discharge pipe temperature thermistor

Ensure the fixture for the thermistor is not lost

Check for sound blanket (back) presence

Remove the sound blanket (back) if present

Pull out the outdoor heat exchanger thermistor

Ensure the clip for the thermistor is not lost

Warning: Wait for 10 minutes after turning off all power supplies before disassembling

Remove the 2 screws of the reactor

Slide the reactor upward to unfasten the 2 hooks

Remove the 2 screws, and then the partition plate

Fit the hole on the partition plate to the hook on the bottom frame

Wait for 10 minutes after turning off all power supplies before disassembling

Remove the 2 earth/ground screws

Check for ferrite core on the earth/ground harness

Unfasten the 2 hooks and remove the PCB

Ensure the 2 projections are fitted to the PCB during reassembly

Wait for 10 minutes after turning off all power supplies before starting disassembly

Remove the 7 screws on the terminal board and disconnect the connecting wire and power supply wire

Remove the 3 screws, and then the wire fixture

Disconnect the connector [S80] (four way valve coil)

Disconnect the connector [S20] (electronic expansion valve coil)

Disconnect the 2 connectors from the reactor

Disconnect the connector [S30] (compressor)