Atlas Copco Oxygen Generator OGP 8

Safety Precautions and Initial Setup

Ensure the following valves are closed

Confirm machine working pressure is 0 bar

Is the generator fully depressurized and purged with air?

Vent oxygen to the outside atmosphere

Ensure no smoking or open flames near the oxygen generator

Set the generator in Manual mode

Pre-Inspection Safety Precautions

Close the generator's outlet valve and the air inlet valve

Ensure machine working pressure is 0 bar

Ensure generator is fully depressurized

Purge thoroughly with air to remove all oxygen

Vent oxygen to the outside atmosphere

Ensure no smoking or open flames in the vicinity of the oxygen generator

Avoid closing valves too fast to prevent high gas velocities

Close the generator's outlet valve and the air inlet valve

Wait until machine working pressure is 0 bar

Ensure the generator is fully depressurized and purge thoroughly with air

Vent oxygen to the outside atmosphere

Prohibit smoking and use of open flames near the oxygen generator

Avoid closing valves too fast to prevent hazardous gas velocities

Read safety recommendations and precautions

Close the generator's outlet valve and the air inlet valve

Wait until machine working pressure is 0 bar

Ensure the generator is fully depressurized and purge thoroughly with air

Vent oxygen to the outside atmosphere

Check for damaged wiring or loose connections

Replace the in- and outlet filter cartridges

Read recommendations and safety precautions

Close the generator's outlet valve and the air inlet valve

Wait until machine working pressure is 0 bar

Ensure the generator is fully depressurized and purge thoroughly with air

Vent oxygen to the outside atmosphere

Check for damaged wiring or loose connections

Replace the in- and outlet filter cartridges