SureShot Dispensing Systems Refrigerated Liquid Dispenser AC220­-FP­-02 FlexoShot

Cleaning the Exterior of the Dispenser

Use a soft, dry cloth to wipe down the exterior surfaces of the dispenser.

Wash the stainless steel exterior surfaces with warm, soapy water.

If the water is hard, did you wipe the dispenser dry with a soft cloth to prevent water spotting?

Use stainless steel polish by spraying it on a cloth before wiping down the exterior surfaces.

Wipe the front of the dispenser clean.

Catch Tray Removal and Initial Rinse

Remove the catch tray by lifting it up and off. Does the dispenser have a catch tray?

Rinse the tray with lukewarm potable water.

Ensure the water temperature is at least 140ºF or 60ºC.

Add a good quality general cleaner to the hot wash water as recommended by the detergent supplier.

Wash the tray thoroughly using a bottle brush to reach all corners and crevices.

If a dishwasher is available, was the tray washed on the pot cycle?

Open the door to the refrigerated product compartment

Thoroughly wipe the area around the valve with a warm, soapy cloth or a sanitized handi­wipe

Wipe the area with a damp cloth to remove any soap residue

Close door to refrigerated product compartment

Remove the tank from the dispenser when the product has run out.

Remove and discard the product delivery tube from the tank.

Rinse the tank and cover with lukewarm potable water.

Ensure water temperature is at least 140º F or 60º C.

Add general cleaner to hot wash water as per detergent supplier's recommendation.

Wash thoroughly using a bottle brush for corners and crevices.

Prepare a container of warm, soapy water before disassembling the valve.

Ensure not to dislodge the cable during cleaning.

Turn the power to the dispenser OFF.

Open the dispenser door to the refrigerated product compartment.

Remove the product tanks by following the instructions on page 12.

Remove the catch tray (if applicable) by lifting it up and off.

Remove the 4 pan-head screws securing the front splash panel and remove the panel.