SureShot Dispensing Systems Refrigerated Liquid Dispenser AC330­-PC IntelliShot

Prepare a container of warm, soapy water before disassembling the valve.

Ensure not to dislodge the cable during cleaning.

Turn the power to the dispenser OFF.

Open the dispenser door to the refrigerated product compartment.

Remove the product tanks by following the instructions on page 12.

Remove the catch tray (if applicable) by lifting it up and off.

Remove the 4 pan-head screws securing the front splash panel and remove the panel.

Is there any ice build-up in the dispenser?

Gently remove ice build-up, if any ice forms.

Is the ice build-up removed during a defrost cycle?

Unplug the dispenser and leave the door open for about 15 minutes to allow ice to soften.

Is a temperature adjustment required?

If temperature adjustment is required, describe the issue.

Remove the product case from the refrigerated product compartment of the dispenser

Wash with hot, soapy water or an approved sanitary cleaning product

Rinse with hot, clear water to remove soap residue

Is the case cleaned each time the valve is cleaned or more frequently if required?

Catch Tray Removal and Initial Rinse

Remove the catch tray by lifting it up and off. Does the dispenser have a catch tray?

Rinse the tray with lukewarm potable water.

Ensure the water temperature is at least 140ºF or 60ºC.

Add a good quality general cleaner to the hot wash water as recommended by the detergent supplier.

Wash the tray thoroughly using a bottle brush to reach all corners and crevices.

If a dishwasher is available, was the tray washed on the pot cycle?

Prepare a container of warm, soapy water

Ensure not to dislodge the cable during cleaning

Turn the power to the dispenser OFF

Drain product tanks and remove empty tanks

Open the door to the refrigerated product compartment

Remove the catch tray (if applicable) by lifting it up and off

Remove the 4 pan-head screws and the front splash panel/valve cover